SKF bearing in the middle of use, many people only pay attention to a big problem. Didn't see some small issues. Cases as a result of SKF bearing damage caused by these small problems, and even the end of life.
Poor is a filter effect air filter or intake system sealed well, to check the air intake system of pipes and connections, there is no break loose and, at the same time check the filter for loose paper core there is no break. Both the maintenance and the maintenance check of the entire intake system is very important, you must ensure that reliability.
Joined the engines after the second is contamination of lubricating oil or engine oil and filter use for too long all of the filters are clogged, so the lubrication oil on the surface of directly into the filter without filter.
Third, fuel and oil leakage in burning up too high volume, nozzle, resulting in fuel into the crankcase, while some impurities with fuel into the crankcase and oil mixed together reduce the lubricating effect.
Therefore engines in use to observe engine exhaust and running, as there are exceptions to identify reasons for repair or replacement in a timely manner.
Four is the engine Assembly, poor cleanliness of internal parts. At the time of repair and maintenance of engines, be sure to note parts clean, installation should pay attention to prevent further pollution, to ensure that after installation of internal cleanliness.
SKF bearing the rolling surface indentation or if there are cracks, rust, will attack like rivet rivets periodic vibration and noise, their cycles can be fixed but most speed into this corresponding relationship, scars will continue attacks on the channel, scars on the ball disappeared, and included with the unit and this noise smoothing prerequisite and inevitable change.
Such moderation approach to noise: percussion devices when not bearing, SKF bearings and shaft Assembly, then avoid bearing when mounted in housings mounted helical; avoid inventory to avoid bearing corrosion and transportation impact vibration use smoothing of high viscosity grease.
Dust and other foreign bodies within the SKF bearings, will attack non-periodic vibration and the so-called dust, vibration and noise of their large and indefinite, and or with or without.
Moderation approach to dust: improving the washing of SKF bearings, bearings, shafts, before device full bore and match parts tough clean Shen Qing; put foreign objects inside the smooth agent; improve bearing seal; preventing application information pure or stick with embedded foreign body.



Other News:
Small particles caused by injuries in SKF bearings noise detection method
Standard method of installing disperser of SKF bearings and lubrication and maintenance
INA bearing the correct common installation problems
Clearance structure on TIMKEN bearings are major causes of Burns
Powder mixing equipment FAG bearing lubrication technique solution of Raceway noise analysis
Environmental considerations on impact strength of the use of FAG bearings
Proper use of NSK bearings need to pay attention to what issues
Several points to note the correct installation of NSK bearings knowledge elements